Gun Auctions

THIS LISTING IS ARCHIVED AND NO LONGER ACTIVE


Listed By: DLR-INGRAM

MAC Powder Springs Parts Set 9mm

Sept. 1, 2019, 2:30 p.m. - Unknown Section -
Listing Details

MAC Powder Springs Parts Set 9mm

Item Description

ATTENTION: This listing is for a buyer to obtain the necessary paperwork to safely market their refinished MAC receiver as "refurbished using all original mint, never fired, Powder Springs parts". Early 70’s parts are in high demand because Military Armament Corporation applied an expensive high temperature heat treating process to the metal, making them last longer. This was only done in the early 70’s to make MACS marketable for potential military contracts. Up for sale is a complete mint, unused Powder Springs parts set. This parts set is for your 9mm Powder Springs or early RPB over-stamp receiver. (Receiver not included but one is available for an extra charge. Please read the bottom of the description for details) All of these parts pictured were produced in the early 70’s. This set will only fit the MAC Powder Springs or early RPB over-stamp receivers that has the lower notch cut out, which is located under the barrel. Parts set does not come with a mag. Walther MP9 Mags are extra. Please read description below for price. This parts set came off a never used, still sealed in original factory bag, complete Powder Springs Ingram. This NFA Firearm was sealed in the factory bag and stored away since the 70’s until I purchased the MAC in Oct 2009 from Ruben Mendiola. I carefully stripped the mint parts set from the receiver and then transferred the stripped receiver in Jan 2012. After I removed the entire parts set, I then stored them in an air tight sealed box with silica to insure their mint condition. If you have plans to refinish your receiver and then install this part set, you can then market your newly refurbished NFA MAC as mint and never used. By installing this parts set on your refinished receiver, it will increase the marketability of your investment 3 or 4 times its current value. MOST IMPORTANT TO ANY BUYER: Parts set comes with a significant amount of paper work to establish provenance. Provenance includes previous email communications, copies of BATF transfers, original auction listing and pictures, and a notarized affidavit. This provenance guarantees that the buyers investment purchase will continue to increase in value and that this parts set is unused and in mint condition. . . . EXTRA POWDER SPRINGS WALTHER MPL MAGS 9MM – $ 225.00 each These are original mac 9mm magazines from Powder Springs. Extremely hard to find and essential for your investment if you own a MAC receiver for 9mm. Original Magazines are all early 70’s production. The original MAC Walther MP9 magazines practically guarantees flawless feeding and functioning. Magazines shows slight wear to finish and are like new. These particular magazines individually list for 250.00 on other auction sites. . . . POWDER SPRINGS RPB OVER STAMP SMG 9MM – $ 6850.00 Also up for sale is a Powder Springs RPB Over-Stamp SMG in 9mm. Lower receiver was manufactured by Powder Springs in the early 70’s and was later registered by RPB when Military Armaments Corporation sold all their inventory to them due to bankruptcy. Lower receiver was manufactured with the early retaining pin notch for the early Powder Springs parts sets. Lower receiver has no cracks, dings, dents, and welds are perfect. Lower receiver has never been repaired, and except cosmetically, is in great flawless condition. 20 to 30 percent of finish has worn off the lower receiver and it needs to be re-parkerized. Add your Powder Springs, Marietta GA, RPB, or Lage Parts Set to this, and you will have a significant investment. The first owner bought this MAC in the 70’s and sold it to me in 2006. Buyer will be its third owner. Comes with a free 2006 AWC MK9 suppressor which has been refurbished. Sent back to AWC, it has been completely cleaned, sandblasted, and repainted. Since being factory refurbished, the suppressor is unused, unfired, and mint. Both MAC and AWC suppressor are on Form 4 in Texas. . . . I take PayPal, cashier’s check, or money order. I will be happy to email more detailed pictures and answer questions. Shipping for parts set is 85.00 which includes insurance. Email me for a quote on shipping for extra mags and NFA items.

Extra Details

  • Publish date: Sept. 1, 2019, 2:30 p.m.
  • Expiring Date: Sept. 29, 2019, 9:01 p.m.
  • Shipping Cost: $85.00

Seller Info

  • Shipping: Seller Will Ship!
  • Location: Texas
  • Listing ID: #1019

Related Listings:

Other listings you might like!